Tool to adjust truss rod on a bass guitar?



Asked by: Terrell Hobbs

A genuine Fender truss rod wrench is exactly the right tool to use when setting up and maintaining your Fender bass. 3/16″ “T-Style” Ball-End Hex (AllenHex (AllenAllen is a brand of hand tools, most widely recognized for its wrenches, known generically as “Allen wrenches”. As a brand, it is owned by Apex Tool Group.

How do I adjust the truss rod on my bass?






So if it's lifting that means that the truss rod is just a hair tight. So we need to loosen it to loosen that we go in a counterclockwise. Direction.

Do you need a special tool to adjust truss rod?

The tool needed for this adjustment is a 1/4″ ‘nut driver’ wrench available at any hardware store such as Ace. They used to be small enough to fit, but recently many driver brands seem a little too large and some grinding on the outside diameter may be necessary.

Can you use an Allen wrench to adjust truss rod?

Most modern guitars have an Allen bolt that is adjusted with, you guessed it, an Allen wrench or key. When you’re adjusting the truss rod, make sure the Allen key is seated properly in the truss rod nut; push it all the way in. If you don’t, the nut can be damaged when you try to turn the wrench.

Should you loosen bass strings before adjusting truss rod?

You only need to loosen your guitar strings before adjusting your truss rod if you want to tighten the truss rod. Tightening the truss rod creates extra tension on the strings, which can cause problems. If you want to loosen your truss rod, you don’t need to loosen your strings.

What tools do I need to set up a bass?





Action with minimal fret buzz now there really aren't very many tools that you actually need to do a good setup on your bass. So the first is going to be a Phillips head screwdriver. The second are

How high should the action be on a bass?

If the distance from the top of your frets to the bottom of your strings is short you have low action on your bass. As a general rule, low action is between 1/16th” and 9/64″, or 1.6mm to 3.5mm.

Can you use a screwdriver on a truss rod?

It’s a brilliant idea that makes it very easy to adjust a truss rod. Simply insert a small metal rod or a miniature screwdriver into one of the exposed holes and rotate the wheel right to tighten or left to loosen.

What size is a truss rod wrench?

The size of the wrench for the trusd rod is 5mm. Older Guitars and Basses: The size of the Allen socket wrench for the trust rod is 8mm but there may be some variation on some models.

What size Allen wrench is a truss rod?

5MM Allen Truss Rod Wrench.



Is truss rod Allen key?

Not every truss rod uses an Allen key for adjustment – for example, Taylor guitars need a special Phillips head screwdriver and a 1/4″ nut driver. But if your guitar has the original truss rod, some Squiers take a 3/16″ Allen key.

How do you use a truss rod wrench?

In your screwdriver then it will just fall everywhere you'll be looking on the ground for it go ahead and just gently move it down.

Are all truss rods the same size?

Different guitar builders use different size truss rods and you need the specific type wrench and exact size for your guitar. Some truss rods are adjusted with a socket wrench while others use an allen wrench and others may use different type wrenches.



How should a truss rod look?

So there are two kinds of truss rods that are most commonly. Used the single action rod or a double action rod. This is a single action rod a very common rod and the type that's used in this guitar.

Which way do I turn my truss rod?

Remember in a single action truss rod: tightening the rod (turning clockwise) straightens the neck, loosening (turning anti-clockwise) permits it to bow.