Resolve buzz when plugging my amp headphone out into audio interface?



Asked by: Korry Watson

First try and see if you can clean up the amp signal into the Scarlett. Flip the electrical plug on the amp if it’s not polarized (that used to work in the old days, lol) experiment with the output volume and line/mic switch. If you still have a buzz try the amp into the mixer and see if that’s clean.

Can I plug headphone amp into audio interface?





Connecting Headphones to a Balanced Interface



Make peace with your interface’s headphone output – It may not be loud, but it is free. Double amp to an unbalanced amplifier – Connect a stereo patch cable from your interface’s headphone output to the input of an ordinary headphone amp.

How do I stop my amp from buzzing in recording?

Use Filters. Using a high-pass filter (around 80–100Hz), you can cut the 60Hz hum directly out of the signal. This won’t affect the frequency content of a guitar too much. Similarly, you can use a low-pass filter around 10–15kHz to remove any unnecessary high interference or hiss.

Why is my amplifier making a buzzing noise?

More often than not, when your amp is making a humming sound, it’s caused by dirty power, a bad ground connection, or fluorescent lighting. Below are a few things to consider when dealing with this pesky hum.

Why is my audio interface making noise?

Sources of noisy cables can include: Computer hardware, mains cables, power supplies, internal components. Lights, if you have lighting cables alongside audio cables this can cause problems with noise. Power amplifiers, monitor amps, guitar amps, or anything particularly higher power could introduce noise.

Should I plug headphones into audio interface?





You should plug your headphones into the audio interface as it usually gets good results. Occasionally it is necessary to use studio monitors instead, but some form of audio output will always need to be plugged into the interface. This allows you to hear the sound which you are recording.

How do I connect my amp to my focusrite?

In Focusrite Control, this setting is defined on the Device Settings page. Connect this output to your re-amp box to take the signal from ‘balanced line’ to ‘unbalanced instrument’ level (the level your amplifier is designed for), then connect the output of the re-amp box to your guitar amplifier.

How do I connect my headphone amp to my Focusrite Scarlett?

So this cable has two unbalanced ts lines one for left one for right. And it will merge them into an unbalanced stereo signal with the trs. Connection.

Can Scarlett 2i2 be used as headphone amp?

As a headphone amplifier, the Scarlett 2i2 is sufficient as it has the power to drive headphones with an impedance of up to 200 ohms. If you’re using higher impedance headphones like the 250-ohms Beyerdynamic DT 990 Pros, you’ll need a headphone splitter or amplifier to drive them to maximum volume.

Where do I plug my headphone amp into?

Amp we're going to take outputs 5 and 6 and go right into the input. It's a stereo input on my headphone. Amp. So let's go here stereo input. And we'll make our left and right connections.



Can I plug headphones into line out?

You cannot use either the line out OR the speaker out for headphones. The first will get you nothing but a quiet, distorted sound in your phones, and the second will get you a destroyed pair of phones. You need a headphone preamp.

Can I use headphone jack as line out?

So can a headphone output be a workable substitute for a line level output in other situations? Sure, in a pinch it will usually work okay. Headphone amps usually aren’t as free from noise and distortion as good line amps, but in many situations they can be used without significant degradation in overall sound quality.