Cleaning a Tenor Recorder lever?



Asked by: Lisa Landingin

How do you clean a tenor recorder?





But for occasional cleaning just pop them in the top rack of the dishwasher. And they'll be fine if you don't want to try the dishwasher.

How do you clean a recorder that doesn’t come apart?

Fill the kitchen sink with enough water to submerge the recorder, using about 2 quarts hot water and 1 squirt dish soap. Pour 1/4 cup vinegar into the water to aid with disinfection. 3. Place the base and mouthpiece of the recorder in the soapy water, and let soak for 10 minutes.

How do you clean an old recorder?

So what do first is you separate your recorder. So you separate the head joint. The body and the foot joint into three pieces. And you stick them into the warm soapy water.

What do you use to clean a recorder?

Resin recorders can be washed in one piece using a neutral kitchen detergent. For instruments equipped with keys, take care to avoid allowing the keys to become wet. Grease should be applied to any cork joints when assembling a recorder, but it is not necessary to wipe the grease away every time.

Can I put my recorder in the dishwasher?





NEVER put your wooden recorder in the dishwasher. It could crack your instrument. NEVER soak your wooden recorder for longer than 15 minutes. It could also crack your instrument.

How do you clean a wooden recorder with oil?

And a sock now you're going to put the sock over the end of the recorder to catch the block to prevent it from falling out. Ok. I'll put it in back front that's really helpful.

How often should you clean your recorder?

Things You’ll Need



To remove dirt, saliva, body oils and bacteria that transfer from the hands and mouth to the recorder, clean the recorder every 1 to 2 weeks with an inexpensive cleaning solution.

How do you take care of a recorder?

The easiest way to wash the recorder is to simply run warm water through the holes. And through the instruments. You can put some soap through it but just be sure you rinse it really good wipe.

How do you clean an old wooden recorder?

Wash the area with mild soap and water. Use a terry or microfiber cloth to wipe off any remaining residue. Prevent it from developing again by wiping your beak with a damp cloth after playing it. You can rinse the beak under running tap water too.



What is recorder cream used for?

Overview. Yamaha recorder cream was especially developed for Yamaha recorders. The recorder cream, as well as the Yamaha cork grease, permit smooth operation of the ABS resin joints to ensure positive, airtight sealing.

Should I oil a new recorder?

A new recorder should be oiled very regularly in the first few months. Depending on the type of wood this should be done every three to four weeks. It is much better to oil more often but little at the time rather than drench the recorder in oil only once in a while.

What can you do with old recorders?

Now, if your old musical instruments are too damaged to be used by anyone, you may need to have them recycled. Most instruments, especially those made primarily of wood or metal, can be taken to your local recycling facility. Even metal instrument strings such as the ones from a guitar or piano can be scrapped.



How do you take care of a plastic recorder?

Always store your recorder in its case after you play and clean it. Make sure it is completely dry and then place it back in its case. Always store the case in a low-humidity area and away from high-heat areas. Don’t store the case in direct sunlight or near heat sources such as stoves.

How do I clean my dishwasher recorder?

1. Separate the recorder and run it through a no-heated dry cycle on the top rack of your dishwasher. 2. Separate the recorder, soak it in warm, soapy water for 10 minutes, then wipe the outside clean.

How do you grease a plastic recorder?

You don’t need joint grease for a plastic recorder: Vaseline or anything greasy will do. I have most of my plastic recorders lubricated with anti-inflammatory corticosteroid ointment, that being something I always have handy.

What is recorder joint grease?

Joint grease for recorders is used to keep cork joints and O rings lubricated to ensure easy assembly. This canister is specially made to fit inside the case of most recorders.



What are the parts of a recorder called?

The recorder, much like a flute, is a tubular instrument broken down into three main parts: the head joint, the body joint, and the foot joint. Recorders come in various sizes depending on the pitch you want—sopranino, descant, treble, tenor, or bass.

How many types of recorders are there?

Recorders of all sizes, from small to large



Also, in general, ensembles are quartets that perform with the four types of recorders; soprano, alto, tenor and bass.

What key is a tenor recorder in?

The tenor recorder, like the soprano recorder, is tuned in C, but is pitched an octave lower. Because of its larger size, many tenors have keys to make it easier to play the lowest C and C♯, and occasionally D and D♯.

Are wooden recorders better than plastic ones?

There is more resistance in wooden recorders, and often they are easier to play than plastic ones, especially on the lowest notes. Plastic recorders tend to block up very quickly with moisture, meaning the sound becomes muffled and the instrument is less rewarding to play.