Can I plug a regular distortion pedal in front of a Zoom G5 multi-effects?



Asked by: Chad Cordova

There is no issue with plugging in an effect pedal in front of such multi-effect pedal.

Where do I put my multi effects pedal in my chain?





Typically, most players will find that compression, boost, and dirt pedals are best suited to being first in the signal chain, or perhaps second, right after a wah or tuner (both pedals that may be easily replaced by a multi-effect, by the way). This is a good place to start, as it produces very dependable results.

Can you use a multi effects pedal with an amp?

Two connects the effects end of your multi effects into the input of your amplifier. Cable. Three goes from the amplifiers. Effects end to the effects return of the multi effects unit and cable.

Do I need an amp with a multi effects pedal?

Multi-effects systems with amp and cab modelling can be used live, in the studio or for practice with no need for any other pedals or amplifier. You just plug in one end and your guitars final signal comes out of the other.

Can you use multi effects pedal?

That being said, there are two ways to use a multi effects unit (this also holds true for single effect pedals) – plugging your guitar directly into the effects unit and then plugging into your amp, or running the effects unit through your amp’s effect loop.

Can you mix analog and digital pedals?





You can mix the two, the thing is that Boss pedals usually lack tone with their digitalness (won’t go into detail) and anyways, if you have a really nice analog pedal chances are you might not want to run it through digital, because the other pedal might suck it’s tone, and it’s true with analog and analog, you can

Which comes first overdrive or distortion?

Generally, your distortion, overdrive and fuzz effects pedals should go towards the start of your pedal chain as they have the greatest effect on the tone. Fuzz pedals should usually go first, followed by overdrive and finally distortion.

Can you use a distortion pedal with a tube amp?

Most tube amps won’t need a distortion pedal, digital or otherwise. When an amp has both a dirty (gain) and a clean channel, this allows you to dial your distorted tones along with whatever clean sound you might want to use.

How do you hook up a distortion pedal to an amp?

Onto your distortion pedal and then plug it into your guitar. Like so and then all you have to do is press the foot pedal and it should work that's for the battery.

How do I connect my Zoom pedal to my amp?

How to Connect Effects Pedals to your Amp and Guitar



  1. Make sure your amp is turned off.
  2. Connect your guitar cable to your guitar.
  3. Then plug the other end into the “input” side of your pedal.
  4. Plug another guitar cable into the “output” side of your pedal.
  5. Then plug the other end into the “input” on your amp.


Can you run line level through guitar pedals?

Are there any guitar pedals that can handle line level? A: Yes. There are several that can, such as the TC Electronic TonePrint series of pedals, which were designed to have plenty of headroom for line-level signals. Other TC pedals, such as the Nova Repeater can also work with line level.

How do you tell if a pedal is analog or digital?

Open the pedal up, and if you see the chip with many tiny legs surface mounted on the pcb board… most likely digital. usually the delay/reverbs tend to be digital, especially in a small stompbox.



Is Ibanez Tube Screamer analog?

Ibanez TS808 Tube Screamer Overdrive Effects Pedal Features:



Uses the same JRC4558D IC chip and analog circuitry as the original Tube Screamer. Square footswitch, just like the original Tube Screamer. Gives you a smooth, full overdrive – in the style of an overdriven tube amp.

What Tube Screamer did SRV use?

Ibanez TS-808 Tube Screamer

It’s an Ibanez TS-808 Tube Screamer that was apparently owned, at some point, by the late Stevie Ray Vaughan.

Why are Tube Screamers so popular?

One of the other key reasons the Ibanez Tube Screamer is so popular with blues guitarists, is because of its ‘dynamic response‘. Put simply, the pedal responds very well to the way that you play your guitar. If you dig in and use a heavy pick attack, you’ll get a more aggressive and overdriven tone.



Which Tube Screamer does John Mayer use?

Mayer is known to have played through the TS808, TS9, and TS10 in order to get that “Stevie Ray Vaughan” style of overdrive. Ibanez Tube Screamers are also relatively inexpensive, beginning at $100 for a brand new unit. Another Tube Screamer style overdrive that Mayer is known to use is a Fulltone Fulldrive 2.

How do you get a punchy guitar tone?

And have a bright punchy colorful sound never ever turn the volume down. From the guitar itself the volume knob on the guitar itself should always be open all the way on 10.

How can I sound like John Mayer without busting the bank?

Book beautiful jangly tone. So we can spend a little bit more in the amplifier. I reckon Fender. Some sort of fender combo let's double lives on wall of fender.